Skip to content
KORNDEX – Home

Sanding problem

The disc falls off the backing pad

Also: Hook-and-loop won’t hold · Sanding disc comes off · Hook-and-loop pad worn out

Why does the sanding disc fall off the hook-and-loop pad? Usually the hook-and-loop on the backing pad is worn or clogged, rarely the disc. Cleaning often helps; if the hooks are flattened, fit a new backing pad.

How to spot it

Even a new disc will not stay on; the hooks on the backing pad look flattened or discoloured.

Where it comes from

  • The hook-and-loop on the backing pad is worn – the hooks break or melt when the disc shifts.
  • Dust and resin are stuck in the hook-and-loop.
  • The machine was put down or lifted off while running freely, or guided over edges.

What helps now

  • Clean the hook-and-loop with a soft brush or compressed air – that is often enough.
  • If it is flattened or discoloured: fit a replacement backing pad with the same diameter and hole pattern.
  • Put an interface pad in between: it wears instead of the backing pad and is quicker to replace.

In depth in the guides:Random orbital sander pads not sticking? Causes and fixes Which backing pad for which abrasive?

More sanding defects