Car & paint · 1 min read
Avoiding and removing holograms when polishing
Holograms are hazes of fine circular marks that show in sunlight. They come from polish that is too coarse, too much pressure or sanding that was too coarse – and go away with fine polish.
Last updated:
KORNDEX sells abrasives – matching products are linked below the article.
Short answer: the grit sequence

What holograms are
Where they come from
Usually from a polishing step that was too coarse: the cutting polish leaves marks the fine polish no longer removes. Added to that are too much pressure, a machine staying on one spot too long and sanding that was not fine enough before polishing.
Removing: polish finer
Rework with fine polish and a soft pad at low pressure, in overlapping passes and evenly. If that is not enough, the sanding was not fine enough: rework the spot wet with P2000 and polish again – do not polish harder.
Avoiding
Before polishing sand evenly wet up to P2000, keep the order cutting polish then fine polish, work with little pressure and keep the machine moving.
FAQ
How do I get rid of holograms?
Rework with fine polish, a soft pad and little pressure. If they remain, the sanding was too coarse: rework wet with P2000 and polish again.
Why do holograms only show in sunlight?
Because they are fine scratches that refract the light; they only stand out in hard, direct light.

