Car & paint · 1 min read
Polishing paint after sanding: from P2000 to high gloss
After P1500 and P2000 wet the surface is evenly matt. How cutting polish, fine polish and the machine work together – and when the sanding is not yet fine enough.
Last updated:
KORNDEX sells abrasives – matching products are linked below the article.

What has to be done before polishing
Polish only removes sanding marks that are fine enough. So: P1500 wet first, then P2000 (P3000 as well if you want it especially fine), each time evenly over the whole surface until the marks of the previous grit are gone. Skipping a grit shows up in the polishing step, not before it.
Rinse and dry the surface before polishing so no grit gets into the compound.
From cutting polish to fine polish
Cutting polish (coarse) removes the fine sanding marks and brings up the first gloss. Fine polish brings out the depth and removes the holograms the first stage leaves. Never reverse the order.
Work only about half a square metre per pass, with little compound and moderate pressure. With the machine, do not stay on one spot – heat softens the paint and can burn through it.
Machine or by hand
Small spots and scratches can be polished by hand with a sponge or cloth; larger surfaces come out more evenly with a polishing machine. A random orbital sander is not made for polishing: it is built for abrasives, not for polishing pads.
Mask edges, creases and trim and work away from them.
If sanding marks remain after polishing
If scratches or matt patches remain, the sanding was not fine enough or not even. Then do not polish harder, go back: rework the spot wet with P2000 and polish again. More pressure or time with the compound only takes off clear coat.
If the clear coat gets too thin, the colour shows through – from there only repainting helps.
FAQ
Do I have to sand before polishing?
Only if the defect is deeper than the compound removes. Fine scratches and dull spots often need polish alone; anything you can feel with a fingernail needs wet sanding first.
Is P2000 enough before polishing?
For most cases yes. If you want an especially deep reflection, also sand P3000 – then there is less work in polishing.
Terms in this article
All terms in the sanding glossary →The whole sequence at once
2 grits, 1 × smallest pack each: PRO SHEET 230 × 280 wet (25 pcs) P1500 · P2000.
Or as a set: Finish set for high gloss (P1000–P2000) for €59.90 →
incl. VAT, plus shipping

