Skip to content
KORNDEX – Home

Sanders & technique · 1 min read

Interface pad: when an intermediate layer makes sense

On curves, on edges, with fine grits and with mesh discs. Why the intermediate layer makes the scratch pattern more even – and when to leave it out.

Last updated:

KORNDEX sells abrasives – matching products are linked below the article.

Sanding discs, sheets, a roll and sanding sponges next to a painted panel, wood, steel and plastic

The answer in one paragraph

An interface pad is a soft intermediate layer with hook and loop on both sides. It makes the disc follow curves, protects edges and spreads the pressure more evenly. You need it for fine grits and the finish, on curved surfaces and with mesh discs with an open structure. On flat surfaces with coarse removal you leave it out.

When it helps

On curves and creases so the disc follows the surface and does not sand edges. In the finish from P400, where a soft base prevents streaks and pressure marks. With mesh discs, which extract dust better through a pad with an open structure.

When to leave it out

When flat sanding filler or wood with coarse grit the surface is supposed to become level. A soft intermediate layer would only trace the low spots. A hard pad is better there.

Size, perforation and replacement

The pad has to fit the backing pad: same diameter, matching perforation for the extraction. Pads that are too large overhang and tear at the edge, too small ones leave hook material exposed. The pad is a wear part; replace it when it shows hollows or brittle spots.

FAQ

Do I always need an interface pad?

No. It helps on curves, fine grits and mesh discs. When flat sanding with coarse grit it stays off.

When do I replace the interface pad?

When it shows hollows, brittle or torn spots, or the disc no longer sits flat.

Terms in this article

All terms in the sanding glossary →

More on this topic

Matching products

  • KORNDEX

    Soft interface pad

    Soft interface pad Ø 125 or 150 mm – for contours and for mesh discs.

    €8.90

    incl. VAT, plus shipping

  • KORNDEX

    Hook-and-loop backing pad

    Hook-and-loop backing pad for random orbital sanders – 15 holes, 5/16" thread.

    €18.60

    incl. VAT, plus shipping

  • KORNDEX

    PRO NET 150

    Mesh sanding disc Ø 150 mm – virtually dust-free, sands for longer.

    €24.90

    €0.50 / pc · incl. VAT, plus shipping

  • KORNDEX

    SOFT FINISH

    Foam sanding pad Ø 150 mm – perfect results. Every time.

    €14.90

    €1.49 / pc · incl. VAT, plus shipping

  • KORNDEX EX 150 with extraction hose on the workbench, with P120, P240 and P400 sanding discs in front

    KORNDEX EX 150

    Random orbital sander 150 mm, 5 mm orbit, 350 W – the machine for our discs.

    €149.00

    incl. VAT, plus shipping