Abrasives · 2 min read
6, 8 or 15 holes? Which hole pattern fits my backing pad?
Hook and loop holds, holes extract. How to count the hole pattern on your pad, when multi-hole and mesh fit – and why you should not punch discs yourself.
Last updated:
KORNDEX sells abrasives – matching products are linked below the article.

Hook and loop and holes: two different things
Hook and loop is the attachment: the hooks on the pad grip the loop fabric on the back of the disc. The holes are the extraction: through them the sander pulls the dust away from under the disc. A disc can have hook and loop and still not fit if its holes sit somewhere other than those in the pad.
The common variants: hook and loop without holes – holds, but does not extract, for work without extraction. Hook and loop with 6 or 8 holes – fixed patterns that have to match the pad exactly. Hook and loop with 15 or more holes (multi-hole) – many holes, fits several patterns. Mesh – open everywhere, needs no hole pattern.
How to count the hole pattern on your pad
Unplug the sander, turn it over and count the holes in the hook surface: the holes in the outer ring, plus a possible centre hole and an inner ring. On 150 mm, 6 holes and multi-hole pads with 15 or more holes are common; on 125 mm, 8 holes. Every manufacturer has exceptions – better to count than to rely on the model name.
Then put a disc on: if every hole in the disc sits over a hole in the pad, it fits. If a hole sits on hook material, it does not extract; if a pad hole sits under solid paper, it stays closed.
What happens when the hole pattern does not match
The extraction barely pulls any more. The dust stays between disc and surface, the disc clogs, gets hot and cuts pigtails. On primer surfacer and body filler it is blocked within a few minutes, and the hot pad loses its hook grip sooner.
Multi-hole and mesh: fit almost every pad
Multi-hole discs have so many holes that some always sit over the pad holes – whether the pad has 6, 8 or more. A multi-hole pad does the same from the other side: it takes discs with different hole patterns.
Mesh discs are open across the whole surface and extract on any hook-and-loop pad. A perforated interface pad in between spreads the extraction over the whole surface.
Hook and loop or self-adhesive?
Self-adhesive (PSA) discs stick to a smooth pad with an adhesive layer. They sit very firmly and flat, but can only be stuck on once – peeling off, checking and putting back is not possible, and adhesive residue stays on the pad. That is why hook and loop has won out in the workshop: changing a disc takes seconds, and a half-used disc can carry on later.
Hook and loop and adhesive pads do not mix. Hook-and-loop discs belong on a hook-and-loop pad, self-adhesive discs on a smooth pad.
FAQ
Can I punch holes in sandpaper myself?
For clamp paper on an orbital sander, yes, with the sander’s punch plate. Punching hook-and-loop discs yourself is not worth it: the holes rarely line up exactly, they tear, and the hook material underneath rubs along.
Why are there pre-punched discs at all?
Because extraction only works through holes that sit exactly over those of the pad. Pre-punched holes are clean, without tears – and the disc stays open for longer.
Does a 6-hole disc fit a 15-hole pad?
On a multi-hole pad usually yes, because it has holes in the positions of the common patterns. The other way round, a multi-hole disc on a 6-hole pad, fits as well.
