Skip to content
KORNDEX – Home

Coarse · Heavy stock removal

Sandpaper P40 P40 grit (FEPA)

Stripping. Remove old paint and rust, heavy stock removal on wood.

Roughly equivalent to 40 Grit (US CAMI standard).

01 · Where it fits

Where P40 sits in the sequence

Before

P40 is the starting point: only go coarser for heavy removal.

Coarse range

P24–P80: Strip old paint, rust and rough unevenness, shape body filler. Leaves visible scratches – always work finer afterwards.

After

Carry on with P60 until the surface is as fine as the next job needs.

P40 in practice

Used on
Solid wood such as floorboards and beams, thick old paint, rust on steel.
Tools
Random orbital sander with 5 mm orbit or a belt sander; hand block only for small spots.
Typical mistake
Staying on one spot too long: P40 digs hollows into soft wood that P80 can barely remove.
Tip from the workshop
Stay coarse only as long as you need to. As soon as the old coating is off, switch to P60 or P80 – every extra pass with P40 costs two finer ones later.

Is P40 the coarsest grit?

In the grit sequence for random orbital sanders and hand blocks, P40 is the coarsest step. The standard has even coarser grits such as P24 or P36 – they belong on belt and floor sanders when whole floors are stripped. P40 is enough for thick paint, rust and weathered wood; move on to P60 or P80 as early as you can.

In the KORNDEX system:Preparation · Remove old paint & rust P40–P120

What P40 is used for

02 · Buy

Products in P40

We don't stock P40 at the moment – the nearest available grit:

03 · Know-how

FAQs about P40

What is P40 sandpaper used for?

Stripping: Remove old paint and rust, heavy stock removal on wood. Typical for Wood, Metal.

Is P40 coarse or fine?

P40 belongs to the coarse range (P24 to P80): heavy stock removal. The higher the number, the finer the grit.

Which grit comes after P40?

After P40 comes P60. Never more than double the number per step – that way the finer grit removes the scratches of the coarser one.

Should P40 be used wet or dry?

Dry, with dust extraction – up to about P600 that is the standard today: faster, and no water in the metal or wood. Mesh discs and multi-hole patterns stop P40 from clogging.

What do you sand P40 with?

Random orbital sander with 5 mm orbit or a belt sander; hand block only for small spots. Typical for: Solid wood such as floorboards and beams, thick old paint, rust on steel.

What is the most common mistake with P40?

Staying on one spot too long: P40 digs hollows into soft wood that P80 can barely remove. Stay coarse only as long as you need to. As soon as the old coating is off, switch to P60 or P80 – every extra pass with P40 costs two finer ones later.

Not sure P40 is right?

The finder asks about material, machine and goal – and tells you the grit and product.

Start the abrasive finder →