Skip to content
KORNDEX – Home

Sanding problem

Sanded through – primer, wood or chipboard is exposed

Also: Sand-through · sanded through · Sanded through veneer · Bare edge

How do I avoid sand-through on edges and veneer? Sand edges and curves by hand, never tilt the machine and never run it over the edge. A soft interface pad spreads the pressure so the edge of the backing pad does not cut in.

How to spot it

The colour suddenly changes on edges and curves; on veneer, a different wood grain or glue shows through.

Where it comes from

  • The machine was tilted, or put down or lifted off with the pad running – then the edge of the pad cuts in at one spot.
  • Started too coarse where only a scuff sand was needed.
  • Sanded over the edge, where the disc flips up.

What helps now

  • Stop immediately: sanded-through veneer cannot be recovered; on paint it means priming and building up again.
  • Do edges, corners and curves by hand with a block or non-woven abrasive, not with the machine.
  • Put a soft interface pad under the disc so the edge of the backing pad does not cut in – and set the machine down flat before switching it on.

Grits to put it right

Read the full sequence:Wood Car & paint

In depth in the guides:Sanding veneer without sanding through Sanding edges, profiles and curves Using a random orbital sander: pressure, speed, pace

More sanding defects