Skip to content
KORNDEX – Home

Metal · 1 min read

Keying before bonding: metal and plastic

Adhesive holds on a rough, clean surface: P80 to P120 on metal, P180 to P240 on plastic – and why you degrease before and after sanding.

Last updated: · published

KORNDEX sells abrasives – matching products are linked below the article.

Short answer: the grit sequence

Random orbital sander levelling the weld seam on a square tube

Why key the surface

Adhesive holds best on a fresh, rough surface. Oxide layers, mill scale, grease and release agents get in the way and make the bond fail later. Sanding removes them and at the same time increases the surface area the adhesive can grip.

Metal

Degrease first – otherwise the abrasive just spreads the grease around. Then sand crosswise with P80 to P120 until the surface is bright and evenly rough all over. Blow or wipe off the dust and degrease again. Don’t touch the surface with your fingers after that.

Aluminium quickly forms a new oxide layer: bond it within an hour if possible. With steel, a few hours are fine as long as the surface stays dry.

Plastic

Rough up plastic with P180 to P240 or non-woven abrasive, without deep scratches – the plastic should go matt, not scratched. Wipe it before and after with a cleaner suitable for plastics.

Polyethylene (PE) and polypropylene (PP) are hard to bond even after keying; they need a primer or a special adhesive. The material code is usually moulded on the inside of the part.

FAQ

Can I use non-woven abrasive instead of sandpaper?

On plastic and thin sheet metal, often yes – it roughens evenly without deep scratches. For rust, mill scale and scale on steel, sandpaper with P80 to P120 is faster and more thorough.

Terms in this article

All terms in the sanding glossary →

The whole sequence at once

4 grits, 1 × smallest pack each: PRO CUT 150 (10 pcs) P80 · P120 · P180 · P240.

incl. VAT, plus shipping

More on this topic

Matching products

  • KORNDEX

    PRO CUT 150

    Professional sanding disc Ø 150 mm – maximum stock removal.

    €24.90

    €0.50 / pc · incl. VAT, plus shipping

  • KORNDEX

    PRO STRIP 70 × 420

    Sanding strips 70 × 420 mm with hook and loop – for hand blocks and orbital sanders.

    €22.90

    €0.92 / pc · incl. VAT, plus shipping

  • KORNDEX

    PRO FLEECE

    Abrasive fleece 152 × 229 mm – matting, cleaning and scuffing without scratches.

    €14.90

    €1.49 / pc · incl. VAT, plus shipping

  • KORNDEX

    Hand sanding block 70 × 198

    Hand sanding block with hook and loop and extraction port – for strips and rolls.

    €14.90

    incl. VAT, plus shipping