Plastic & resin · 1 min read
Sanding 3D prints: grits to remove layer lines
Layer lines on PLA, PETG and resin: coarse with P120 to P180, then up to P400 – and wet from P600 so the plastic doesn’t melt.
Last updated: · published
KORNDEX sells abrasives – matching products are linked below the article.

Coarse against the layers
Don’t let it get warm
PLA softens at around 60 degrees. Light pressure, short strokes, breaks. From P400, sand wet: the water cools and binds the dust. Always wet-sand resin prints and wear gloves while you do – uncured resin irritates the skin.
Prime or sand smooth
If you want to paint, spray on a filler primer after P240, sand it with P320 to P400 and paint. For a smooth surface without paint, carry on wet sanding up to P600 or P800.
FAQ
Can I sand PETG the same way as PLA?
Yes – PETG is a little tougher and smears more easily. Use light pressure, switch to wet sanding early and change the disc or sheet more often.
The whole sequence at once
7 grits, 1 × smallest pack each: PRO STRIP 70 × 420 (25 pcs) P120 · P180 · P240 · P320, PRO SHEET 230 × 280 wet (25 pcs) P400 · P600 · P800.
Or as a set: Finish set for high gloss (P1000–P2000) for €59.90 →
incl. VAT, plus shipping


